Lamination Tips, Its a Fast TUT.....

Lamination Tips, Its a Fast TUT.....

Lamination Tips
By Frank White
When laminating the ID with the matte pouches you want to be sure to put the sealed half of the pouch in the laminator first, so it wont bend in the laminator.
A lot of the times people want to use glue when using a transparency over teslin then laminating, but I suggest no glue at all. The outer section of the lamination pouch will hold everything in place once its laminated. It's also good because it helps to past the 'bend test.' The bend test is a test that many bouncers use to see if your ID is real. They simply bend the id end to end, if it tears in the middle, then your screwed.
Some people have asked me if using an iron is out of the question, and well, you must be one cheap ass. It's not worth the trouble to try to laminate an ID with an iron even though it is possible. I have heard suggestions about using some sort of thin cardboard between each side of the ID, but I have never tried that myself, good luck if you do!
Another ID is to buy the iron on badge holders. But this just simply will not work. The size needed for a typical ID is between 25-35 mils, and dimensions of 2 1/8 x 3 3/8, using one of these badge holders is not an option.
Definitely run your ID through the laminator 3 times. 1 time just doesn't do it. You need it completely sealed.
One more thing to remember is depending on what type of lamination pouch you are using and what type of material you are using to print on, you need to adjust the size of the ID accordingly. For example, if you were laminating teslin, since it has unique bonding properties that adhere to the actual pouch when laminated, the id can actually extend over the rim of the ID and trimmed later. On the other hand, if you use glossy paper (not recommended for any state), you would need to cut the ID slightly smaller so the pouch can adhere to itself. Then again, if you have a butterfly pouch, things might be different because the 'glue' on the pouch is not only on the edge, but actually covers the entire id.

Disclaimer:-
i am not liable for any criminal or bad thing which you have done using this message and document. i am giving here for the educational purpose and care should be taken from your side before using this document and please get a written permission from the person before hacking or doing some thing in the network or system.This document is intended for judicial or educational purposes. I have collected these documents and messages from the internet for educational purpose only. always use these documents for doing good only. I don't want to promote computer crime and I'm not responible of your actions in any way. If you want to hack a computer, do the decent thing and ask for permission first. please read and use this for useful purpose only to protect the systems and information from the bad people. always seek permission from the system owner or who ever responcible for the system by written and then go ahead. Give a full report with honestly to the person or company about your experiments and findings from the system. Always Do Good Think Good and Belive Good.